Resources Manufacturing

ICON Plant Tour in Winkler, where Manitoba makers came to meet each other

CME and the Vehicle Technology Centre brought manufacturers from across Manitoba to ICON Technologies in Winkler for lunch, a welcome from John Loewen and Cam Bergen, and a walk through the plant.

On Thursday, November 12, a few dozen manufacturers from around Manitoba sat down to lunch together in Winkler, then walked through ICON Technologies’ plant.

ICON makes large plastic parts, and the moulds for them, and has done it in Winkler for nearly 30 years. Canadian Manufacturers & Exporters (CME) and the Vehicle Technology Centre (VTC) sent out the invitations. mode40 helped put the day together, and ICON opened its doors.

What people came to see

CME and VTC called the day “Working with a Digital Colleague.” Manufacturers hear a lot about AI and digital employees. Far fewer get to see either one at work inside a plant like their own, so the day went to a Manitoba plant where mode40 is already working with the team.

ICON was that plant. mode40’s work there is production scheduling in the rotational moulding department, and ICON has been teaching the schedule which parts run well together on which arm. Teaching software the plant’s own rules is where a digital employee starts: software that does one job, like planning, inside limits the plant sets, and brings anything that needs a decision to a person with its reasons.

Why ICON opened the doors

When we first sat down with Elroy Martens, ICON’s President, to plan the day, he was clear about what ICON wanted out of it. Plenty of Manitoba manufacturers buy large plastic parts from British Columbia, the United States, Europe or China. ICON wanted those buyers to see that parts like that get made a short drive away.

He saw the day as a chance for people to meet, not a day for ICON to chase orders. So it was built around lunch, a few short words at the front of the room, and an open plant.

John Loewen opened the room

John Loewen, ICON’s founder and CEO, welcomed everyone to Winkler. When he handed the microphone to Cam Bergen, mode40’s CEO, the front tables were still clapping.

John Loewen of ICON Technologies hands the microphone to Cam Bergen of mode40 while guests at the front table applaud
John Loewen hands the mic to Cam Bergen.
Cam Bergen speaking into a microphone in front of a stone fireplace, with guests at their tables in the foreground
Cam Bergen at lunch.

A plant that was already ahead

ICON’s floor was never a story about a plant moving off paper. ICON was paperless long before we arrived, with tablets at every workstation carrying work instructions, procedures and safety information. They run an ERP, with their own software sitting between it and our system.

When we first suggested plugging straight into that ERP, ICON’s IT team said “time out,” and we fit around what they had. Elroy asked us to tell that part. Most of the guests in the room run plants with IT teams and systems of their own.

Then everyone walked the floor

After lunch the group moved into ICON’s plant. The first stop put everyone right beside what ICON makes: big white rotomoulded tanks and housings sitting on the shop floor. People stood around them in their own company jackets and kept the lunch conversations going.

Guests in jackets standing on ICON's plant floor, with large white rotomoulded parts in the foreground
Guests on ICON’s floor in Winkler.

Further in, under the high ceilings and ductwork, the group split into smaller circles of people talking.

Small groups of guests talking on ICON's plant floor under a high ceiling and ductwork
Conversations on the floor.

What we took home

Manitoba plants rarely get a look inside each other’s buildings. For one afternoon, ICON opened its doors to a room full of them, and a lot of the talking on the floor was between guests.

Thank you to John Loewen, Elroy Martens and the whole ICON team for opening the plant, to CME and VTC for bringing everyone together, and to every guest who made the trip to Winkler.